NameArtelak Lipid Uno. Release form Drops for eyes. Scope Artelac Lipid Uno is used for intensive and long-term moisturizing of the eye surface Composition Artelac Lipid Uno contains 2 mg/ml carbomer, medium chain triglycerides (lipids), sorbitol, disodium phosphate twelve-water, sodium hydroxide and water for injection. Does not contain preservatives. Release form Artelak® Lipid Uno is produced in dropper tubes for single use of 0.6 ml, a strip of 10 dropper tubes. 1, 3, 6, 12 strips along with instructions for use in a cardboard box. Properties Formulated to help preserve all three layers of the tear film, including the outermost lipid layer: sterile water is used to hydrate, carbomer retains moisture on the surface of the eye, and triglyceride lipids protect the lipid layer of the tear film, which forms a sheath to retain moisture . The gel has a soothing and softening effect on the eye, while inhibiting moisture evaporation, providing long-term symptomatic relief in individuals with suspected dry eye syndrome associated with increased evaporation, as well as for people who need extra strong protection. Artelac Lipid Uno is best suited for soothing and relieving persistent eye symptoms due to chronic tear fluid deficiency. Chronic tear fluid deficiency can be caused by a number of factors, including tear gland inflammation and dysfunction, eye irritation, and/or poor tear quality. When one or more of these factors affect the tear, an imbalance in the tear film develops and then a cascade of unpleasant symptoms develops, including: inflammation of the ocular surface, redness, gritty feeling in the eyes, dryness, sensitivity to light, burning, eye fatigue and soreness, and , ironically, even lacrimation. In addition, certain drugs and procedures (eg, birth control pills, antihistamines, beta-blockers, antispasmodics, diuretics, and cataract surgery), certain diseases, and the preservatives in some eye drops can play an important role in the development of dry eye and corneal damage. Due to the complex mechanism of development of lacrimal dysfunction, treatment causes certain difficulties; However, Artelac® Lipid Uno is designed to replenish all three layers of the tear film, including the outer lipid layer for maximum effectiveness and long-term retention of moisture on the surface of the eye. It has a soothing effect on the eyes and at the same time it locks in moisture to provide long-term hydration. How to use artelac® lipid uno For the treatment of dry eye syndrome, an individual selection of the regimen is required, based on the severity and severity of the symptoms present. It is recommended to instill Artelac® Lipid Uno into the conjunctival sac of each eye, 1 drop 3-5 times a day or more often. It is recommended to wash your hands before using Artelac Lipid Uno. 1. Separate the dropper tube for single use by holding it by the mark. 2. Holding the dropper tube by the label, turn the dropper upside down and shake gently to move the gel to the bottom of the tube. 3. Unscrew the tip of the dropper tube. 4. Slightly tilt your head back, pull the lower eyelid down with the finger of your free hand. Holding the dropper tube as vertically as possible, with the tip down towards the eye, carefully squeeze out one drop. After that, close the eye, move it from side to side and blink several times so that the drops are evenly distributed over the surface of the eye. Contraindications Do not use the product if there is hypersensitivity to the components of the product. Special instructions In case of development of hypersensitivity reactions (irritation or intolerance), it is necessary to stop using Artelac Lipid Uno. In case of increased discomfort when using the product, you should stop using the product and consult an ophthalmologist. Information for patients with corneal injury: In very rare cases, deposition of calcium phosphate in the cornea develops when using phosphate-containing ophthalmic products. Avoid contact of the tip of the dropper tube with your eyes or touching it with your fingers to prevent possible contaminants from entering the solution. In the case of joint use with ophthalmic preparations, it is recommended to observe a pause of at least 15 minutes between instillation of the Artelac® Lipid Uno solution and the use of other eye drops. Contact lenses must be removed from the surface of the eye before using Artelac Lipid Uno. You can put them on again no less than 15 minutes after applying Artelac® Lipid Uno. If blurred vision develops after the use of Artelac® Lipid Uno, driving or operating machinery should be avoided until these symptoms are eliminated. Do not use the product after the expiry date. Check the integrity of the syringe dropper before use. In case of damage, do not use the syringe tube! StorageAt a temperature not exceeding 25 °C in a place protected from light (for example, in the original carton). Buy Artelac Complete Uno solution 0.5ml №30
The code | 129431 |
---|---|
Barcode | 4 030 571 005 360 |
Manufacturer | Dr. Gerhard Mann Chem.-pharm. Fabrik Gmbh, Germany |
Trademark | BAUSCH+LOMB |
trade line | Artelac® |
Scope of application | Ophthalmic products |
Indications Applications | For soothing and alleviating persistent eye symptoms due to chronic tear fluid deficiency |
Contraindications | Do not use the product if there is hypersensitivity to the components of the product |
Use during pregnancy and lactation | Can be used |
Volume (ml) | 15 |
Application Gender | Any |
Release Form | Solution |
Composition Means | 2mg/ml carbomer, medium chain triglycerides (lipids), sorbitol, disodium phosphate twelve-water, sodium hydroxide and water for injection |
Importer | Closed Joint Stock Company "BAUSH HEALTH", 220073, Minsk, st. Olshevsky, 22, room 22 |
Be the first to review “Artelak Complete Uno solution 0.5ml №30” Cancel reply
Related products
Eye drops and gels
Eye drops RELINS moisturizing with L-carnitine and L-menthol, volume 10 ml
$28.00
$32.00
Eye drops and gels
Optinol Wed humid. ophthalmologist. Express moisturizing (volume 10ml)
$28.00
$24.00
Reviews
There are no reviews yet.