NameSolution Artelak® Splash The main active ingredient is hyaluronic acid (in the form of sodium hyaluronate). Release form 10 ml – bottles (1) – packs of cardboard. Dosage Ophthalmic moisturizing solution – 1 ml hyaluronic acid (in the form of sodium hyaluronate) – 2.4 mg Excipients: potassium chloride, sodium chloride, disodium phosphate dodecahydrate, sodium dihydrogen phosphate dihydrate, water for injections. Special instructions When wearing soft and hard contact lenses, Artelac® Splash can be instilled into the conjunctival sac without removing the lenses. Do not use the drug if the package is damaged. Pharmacological action Artelac® Splash contains hyaluronic acid (sodium hyaluronate), which is a natural moisturizing substance with a high ability to bind to water. The tear fluid consists of three layers that provide nutrients to the surface of the eye, form a protective lubricating barrier between the eyelid and cornea, and ensure their normal functioning and clear vision. The natural tear film spreads over the surface of the eye with every blink, protecting the eyes from drying out and promoting healing of superficial corneal lesions. If the balance of the composition of the tear film is disturbed, there may be a feeling of dryness, burning, a foreign body in the eye, irritation and redness of the eyes, a feeling of fatigue, and in some cases lacrimation. Artelac® Splash solution moisturizes the eyes for a long time and helps to stabilize the tear film to ensure a healthy condition of the ocular surface. Artelac® Splash does not contain preservatives. Indications for use 1. For intensive and long-term hydration of the anterior surface of the eye (cornea and conjunctiva) in case of: air-conditioned room, cigarette smoke, strong wind; 3. With severe dry eyes caused by systemic diseases, surgical interventions on the eyes or taking certain medications, such as contraceptives, antihistamines, beta-blockers, antispasmodics, diuretics. 4. To eliminate discomfort when wearing hard and soft contact lenses. Dosage and administration It is recommended to instill Artelac® Splash into the conjunctival sac of each eye, 1 drop as needed. Thanks to the specially designed pumping mechanism of the vial, the solution remains sterile without preservatives. The pictures show how Artelac® Splash should be applied. 1. Each time before using the solution, it is necessary to remove the protective cap of the vial. Do not touch the tip of the vial with your fingers. 2. Place your thumb and forefinger on the round plate of the dispenser near the tip of the bottle, and put your little finger on the bottom of the bottle. Fingers that are located in the middle, you can support the bottle on the sides. 3. Before using the pump for the first time, press the dispenser plate about 7 times before the first drop appears. Hold the vial as shown in the picture. 4. To drip the solution, you should tilt your head back and hold the bottle over the eye in a way that is comfortable. Gently pull the lower eyelid with the finger of your free hand, hold the vial in an upright position and lightly press the dispenser plate. After that, close your eyes and slowly move your eyes in all directions so that the drop is distributed over the surface of the eye. 5. After each use, close the bottle with a cap. 6. You can help yourself with the other hand for more accuracy, if necessary. Do not allow the tip of the vial to touch the eye and touch it with your fingers to prevent contamination of the solution. Interaction with other drugs In the case of joint use with other ophthalmic drugs, it is recommended to observe a pause of at least 15 minutes between instillation of the Artelac® Splash solution and the use of other eye drops. Eye ointments should always be used after instillation of the Artelac® Splash solution. Storage conditions The drug should be stored out of the reach of children at a temperature of 1°C to 25°C. Shelf life in unopened original packaging – 2 years; after opening the vial – 3 months. Do not use after the expiry date stated on the packaging. Buy Artelak Splash solution ophthalm. in vial 10ml Price for Artelak Splash ophthalmic solution. in vial 10mlInstruction for use for Artelac Splash ophthalm solution. in vial 10ml
The code | 80702 |
---|---|
Barcode | 4 029 835 000 159 |
Dosage | 10ml |
Manufacturer | Dr. Gerhard Mann Chem.-pharm. Fabrik Gmbh, Germany |
Trademark | BAUSCH+LOMB |
trade line | Artelac® |
Importer | Closed Joint Stock Company "BAUSH HEALTH", 220073, Minsk, st. Olshevsky, 22, room 22 |
Be the first to review “Artelak Splash ophthalmic solution. in vial 10ml” Cancel reply
Related products
$32.00
Eye drops and gels
Optinol Wed humid. ophthalmologist. Express moisturizing (volume 10ml)
$28.00
$24.00
Reviews
There are no reviews yet.